Angielski chyba mnie przerasta, bo nie potrafie zrozumiec jednej rzeczy.
Jak wlaczyc prawdłowo CLke?
W manualu jest napisane:
STANDBY: The Standby mode
allows the tubes to warm up or remain
warm without high voltage being
applied to them. This extends tube life.
This switch should be OFF when first
turning the amplifier on. Allow the unit
to warm up for 20 seconds before
switching to the ON position. During
short periods of non-use, the amp
should be put into Standby mode.
POWER: This supplies AC power to the unit. Turn this switch on BEFORE turning on the standby switch
Czyli dla potwierdzenia: pozycja startowa to dwa guziki w pozycji off. najpierw wciskam power, czekam pol minuty i potem wlaczam guzik stanby, tak?
Wiem, 30 na karku i klania sie czytanie ze zrozumieniem, ale slyszalem pare innych rzeczy, miedzy innymi od goscia, ktory mi sprzedał ten wzmak i chce sie upewnic
Jak wlaczyc prawdłowo CLke?
W manualu jest napisane:
STANDBY: The Standby mode
allows the tubes to warm up or remain
warm without high voltage being
applied to them. This extends tube life.
This switch should be OFF when first
turning the amplifier on. Allow the unit
to warm up for 20 seconds before
switching to the ON position. During
short periods of non-use, the amp
should be put into Standby mode.
POWER: This supplies AC power to the unit. Turn this switch on BEFORE turning on the standby switch
Czyli dla potwierdzenia: pozycja startowa to dwa guziki w pozycji off. najpierw wciskam power, czekam pol minuty i potem wlaczam guzik stanby, tak?
Wiem, 30 na karku i klania sie czytanie ze zrozumieniem, ale slyszalem pare innych rzeczy, miedzy innymi od goscia, ktory mi sprzedał ten wzmak i chce sie upewnic
outreband.com